Life Fitness Stepper Machine LS8500 User Manual

S t a irc lim b e r  
A S S E M B L Y I N S T R U C T I O N S  
 
IMPORTANT SAFETY INSTRUCTIONS!  
Þ DO NOT locate the Stairclimber outdoors, near swimming pools, or in areas of high  
humidity.  
Þ DO NOT operate your Stairclimber if it has been dropped, damaged, or even partially  
immersed in water. If this occurs, contact Life Fitness Customer Support Services at the  
number in the Operation Manual.  
Þ DO NOT locate the Stairclimber any closer than 30 inches ( 76 cm ) to a television set.  
Þ DO NOT locate additional Stairclimber any closer than a minimum of 42 inches (107 cm)  
from center to center to avoid interference (cross talk) between Heart Rate monitors.  
Þ DO keep the area around your Stairclimber clear of any obstructions, including walls and  
furniture.  
Þ DO verify the contents of the delivery carton against the accompanying Parts Listing prior to  
setting the cartons and shipping material aside. If any parts are missing, contact Life Fitness  
Customer Support Services at the number listed in the Operation Manual. Save the shipping  
cartons in case of return.  
Þ DO read the entire Operation Manual prior to attempting to operate this machine as this is  
essential for proper use.  
CONSIGNES DE SECURITE IMPORTANTES!  
Þ NE placez PAS l'appareil à l'extérieur, près d'une piscine ou dans un endroit très humide.  
Þ NE faites PAS fonctionner l'appareil s'il est tombé, s'il a été endommagé ou s'il a été  
partiellement plongé dans l'eau. Si cela s'est produit, contactez le service après-vente de Life  
Fitness au numéro fourni dans le manuel d'utilisation.  
Þ NE placez PAS l'appareil à moins de 76 cm d'un poste de télévision  
Þ NE placez PAS d'autres appareils du même type à proximité. Un espace d'au moins 107 cm  
doit être observé entre les parties centrales de deux appareils afin d'éviter les interférences  
entre les contrôleurs de rythme cardiaque.  
Þ MAINTENEZ la zone autour de l'appareil libre de toute obstruction, y compris murs et  
meubles. Veillez à laisser un dégagement d'au moins 30 cm devant l'appareil.  
Þ VÉRIFIEZ si l'emballage contient toutes les pièces de la liste jointe avant de le mettre de  
côté. Si des pièces sont absentes, contactez le service après-vente de Life Fitness au numéro  
indiqué dans le manuel d'utilisation. Conservez l'emballage au cas où vous devriez renvoyer  
l'appareil.  
Þ LISEZ le manuel de l'utilisateur tout entier avant d'essayer de faire fonctionner cet appareil.  
Ceci est indispensable à son utilisation correcte.  
 
TOOLS REQUIRED FOR ASSEMBLY... Phillips Screwdriver, Hex Key Wrench, 3/16 Torx  
Screwdriver, Socket Set  
PARTS DESCRIPTION  
1
3
Hex Head Bolt  
Qty: 2  
Qty: 2  
Qty: 8  
Qty: 4  
Qty: 1  
Qty: 1  
Qty: 1  
Qty: 1  
Qty: 1  
Qty: 1  
2
Lock Nut  
Qty: 2  
Qty: 4  
Qty: 6  
Qty: 2  
Qty: 1  
Qty: 2  
Qty: 1  
Qty: 1  
Qty: 1  
Qty: 2  
Hex Head Bolt  
4
Torx Cap Screw  
Flat Head Screw  
Phillips Cap Screw  
Monocolumn  
5
Phillips Cap Screw  
Phillips Cap Screw  
Display Console Assembly  
Accessory Tray  
6
7
8
9
10  
12  
14  
16  
18  
20  
11  
13  
15  
17  
19  
Upright Handrail  
Right Bullhorn Handlebar  
Polar® Receiver  
Heart Rate Cable  
Frame Cap  
Left Bullhorn Handlebar  
Handlebar Assembly  
Telemetry Cable  
Polar Cover  
1
2
3
4
5
6
7
8
 
B
C
1. Before proceeding, familiarize yourself with the parts of the  
Stairclimber and make sure that you have received all the items  
described in the Parts List.  
A
10  
2. Locate the MONOCOLUMN (#10). Position the MONOCOLUMN  
SHROUD (A) onto the MONOCOLUMN as shown. Position the  
MONOCOLUMN near the MONOCOLUMN MOUNTING BRACKET  
(B) as shown. Detach and feed the CONSOLE WIRE HARNESS  
(C) through the MONOCOLUMN and out through the DISPLAY  
CONSOLE MOUNTING BRACKET (D) ACCESS HOLE. Pivot the  
MONOCOLUMN upright and position the locating slot at the  
bottom of the MONOCOLUMN onto the pre-installed LOCATING  
BOLT (E) on the MONOCOLUMN MOUNTING BRACKET. Align  
the mounting holes of the MONOCOLUMN and MONOCILUMN  
MOUNTING BRACKET and secure them together using two  
MOUNTING BOLTS (#1) and LOCKNUTS (#2). Tighten the NUTS  
and BOLTS until snug. Lower the MONOCOLUMN SHROUD until  
it rests on the MAIN SHROUDS.  
D
10  
A
1
CAUTION: BE CAREFUL NOT TO PINCH THE WIRE HARNESS  
WHEN ASSEMBLING THE MONOCOLUMN (#10) TO THE  
MONOCOLUMN MOUNTING BRACKET (B).  
2
E
B
15  
D
3. Align and insert the HANDLEBAR ASSEMBLY (#15) into THE  
HANDLEBAR BRACKET TUBE (F) as shown until the mounting  
holes in the HANDLEBAR ASSEMBLY align with those of the  
HANDLEBAR BRACKET TUBE.  
H
F
10  
 
4. (Model 9500HR / 9100) Locate the TELEMETRY CABLE (#17).  
Feed the 3-PIN CONNECTOR (3P) end of the cable through the  
front of the HANDLEBAR ASSEMBLY (#15). The cable must be  
routed down the HANDLEBAR BRACKET TUBE (F) and back up  
the top of the MONOCOLUMN (#10). Feed the 3-PIN  
CONNECTOR through the DISPLAY CONSOLE MOUNTING  
BRACKET (D) ACCESS HOLE.  
D
3P  
15  
10  
(Model 9500HR) Locate the HEART RATE CABLE (#18). In  
similar fashion, feed the 4-PIN CONNECTOR (4P) end of the cable  
through the front of the HANDLEBAR ASSEMBLY (#15). The  
cable must be routed down the HANDLEBAR BRACKET TUBE  
(F) and back up the top of the MONOCOLUMN (#10). Feed the 4-  
PIN CONNECTOR through the DISPLAY CONSOLE MOUNTING  
BRACKET (D) ACCESS HOLE. Pull the LEFT HEART RATE  
SENSOR CABLE (2PL) (Red/Black) through the LEFT LARGE  
HOLE (H) of THE HANDLEBAR BRACKET TUBE. Pull the RIGHT  
HEART RATE SENSOR CABLE (2PR) (Green/White) through the  
RIGHT LARGE HOLE of THE HANDLEBAR BRACKET TUBE.  
F
17  
2P  
14  
5. (Model 8500 / 9100) Align the USER LEFT BULLHORN (#13) to  
the HANDLEBAR BRACKET TUBE (F). Using three MOUNTING  
SCREWS (#6), secure the USER LEFT BULLHORN to the  
HANDLEBAR BRACKET TUBE and the HANDLEBAR (#15).  
Tighten the SCREWS securely. Repeat the procedure for the  
USER RIGHT BULLHORN (#14).  
2PR  
15  
2PL 2P  
(Model 9500HR) Locate the USER LEFT BULLHORN (#13) with a  
Lifepulse sensor. Connect the 2-PIN CONNECTOR (2P) leading  
from the USER LEFT BULLHORN to the 2-PIN CONNECTOR  
(2PL) now leading from the HANDLEBAR BRACKET TUBE (F).  
Carefully feed any excess HEART RATE CABLE (#18) into the  
HANDLEBAR BRACKET TUBE and secure the USER LEFT  
BULLHORN to the HANDLEBAR BRACKET TUBE using three  
MOUNTING SCREWS (#6). Tighten the SCREWS securely.  
Repeat the procedure for the USER RIGHT BULLHORN (#14) with  
a Lifepulse sensor.  
F
10  
13  
6. Locate the POLAR RECEIVER ASSEMBLY (#16). Plug the  
POLAR RECEIVER ASSEMBLY into the POLAR RECEIVER  
JACK (J). Place the POLAR RECEIVER in a vertical position,  
POLAR RECEIVER JACK facing downward, at the front of the  
HANDLEBAR BRACKET TUBE (F). Position the POLAR COVER  
(#19) over the center of the HANDLEBAR ASSEMBLY (#15) at the  
HANDLEBAR BRACKET TUBE. Making sure the POLAR COVER  
is oriented properly, slide the POLAR COVER over the  
HANDLEBAR ASSEMBLY covering the POLAR RECEIVER  
ASSEMBLY and the end of the HANDLEBAR BRACKET TUBE.  
The POLAR COVER should fully nest over the HANDLEBAR  
ASSEMBLY. Secure the POLAR COVER using two MOUNTING  
SCREWS (#8).  
19  
8
16  
J
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS PAN HEAD  
SCREWS (#8).  
15  
F
8
MISE EN GARDE : NE SERREZ PAS EXCESSIVEMENT LES  
VIS CRUCIFORMES À TÊTE CYLINDRIQUE (Nº 8).  
 
7. Locate the one of the UPRIGHT HANDRAILS (#12). Carefully  
insert the top of the UPRIGHT HANDRAIL into the user right end  
of the HANDLEBAR ASSEMBLY (#15). Align the mounting holes.  
Secure the UPRIGHT HANDRAIL to the HANDLEBAR  
15  
ASSEMBLY using two MOUNTING SCREWS (#4). Position the  
bottom of the UPRIGHT HANDRAIL over the mounting hole in the  
top of the right FRAME LEG (K). Using one HEX HEAD BOLT  
(#?), mount the UPRIGHT HANDRAIL to the right FRAME LEG as  
shown. Tighten the BOLT securely. Repeat the procedure for the  
remaining UPRIGHT HANDRAIL (#12) on the left side of the  
HANDLEBAR ASSEMBLY and FRAME.  
4
12  
8. Lift the MONOCOLUMN SHROUD (A) and tighten the  
MONOCOLUMN BOLTS (#1) securely.  
K
9. (Model 9500HR, 9100) Using four MOUNTING SCREWS (#5),  
attach the ACCESSORY TRAY (#11) to the DISPLAY CONSOLE  
(#9) as shown.  
3
10. Attach all CABLES (L) leading from the DISPLAY CONSOLE  
MOUNTING BRACKET (D) ACCESS HOLE to the back of the  
DISPLAY CONSOLE (#9).  
11. Feed any excess cable into the MONOCOLUMN (#10). Using four  
MOUNTING SCREWS (#5), secure the DISPLAY CONSOLE  
(#9?) to the DISPLAY CONSOLE MOUNTING BRACKET (D).  
9
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS HEAD PAN  
SCREWS (#5).  
11  
CAUTION: BE CAREFUL NOT TO PINCH THE WIRE HARNESS  
(E) WHEN ASSEMBLING THE  
CONSOLE ASSEMBLY (#9) TO THE  
DISPLAY CONSOLE MOUNTING BRACKET (D).  
L
5
MISE EN GARDE : NE SERREZ PAS TROP LES VIS  
CRUCIFORMES À TÊTE CYLINDRIQUE (Nº 5).  
MISE EN GARDE : VEILLEZ À NE PAS PINCER LE FAISCEAU  
DE CÂBLES (E) LORS DU MONTAGE DE LA CONSOLE (Nº 9)  
SUR SON SUPPORT (D).  
D
5
12. Secure the MONOCOLUMN SHROUD (A) to the MAIN SHROUD  
using four MOUNTING SCREWS (#7).  
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS HEAD PAN  
SCREWS (#7).  
10  
MISE EN GARDE : NE SERREZ PAS TROP LES VIS  
CRUCIFORMES À TÊTE CYLINDRIQUE (Nº 7).  
13. Insert the FRAME CAPS (#20) into the ends of the FRAME LEGS  
(K).  
20  
K
 
PRE-OPERATION CHECKLIST  
ü Ensure that all fasteners are tight.  
ü Make sure the Stairclimber is properly leveled and stable.  
(Refer to the Operation Manual)  
ü Ensure that the Leveler Jam Nuts are tight.  
(Refer to the Operation Manual)  
ü Read the entire Operation manual before using the Stairclimber.  
LISTE DES VÉRIFICATIONS À EFFECTUER AVANT LA MISE EN MARCHE  
ü Vérifiez si tous les dispositifs de fixation sont serrés  
ü Vérifiez si l'APPAREIL D'EXERCICE POLYVALENT est de niveau et stable.  
(Référez-vous au manuel d'utilisation.)  
ü Vérifiez si les contre-écrous des vérins de mise à niveau sont serrés.  
(Référez-vous au manuel d'utilisation.)  
ü Lisez le manuel d'utilisation dans son intégralité avant d'utiliser l'appareil d'exercice  
polyvalent.  
Before attempting to operate your Stairclimber, it is imperative that you familiarize yourself with the  
contents of the Operation Manual. If your Stairclimber does not respond as described in the OPERATION  
MANUAL, contact the nearest Life Fitness service center as listed in the Operation Manual.  
© 2002 Brunswick Corporation. All rights reserved. Life Fitness is a trademark of Brunswick Corporation.  
 
Polar is a registered trademark of Polar Electro, Inc.  
M051-00K20-A307  
4/02  
 

KTM Automobile Parts 525 EXC 2006 User Manual
Learning Resources Inflatable Bouncy Toy LER 1801 User Manual
LG Electronics GPS Receiver LN500 User Manual
Lincoln Electric Power Supply LTW1 User Manual
Lowrance electronic GPS Receiver LCX 17M User Manual
Makita Chainsaw 5012B User Manual
Makita Home Safety Product ML18 User Manual
Marshall electronic Flat Panel Television V R1041DP TE User Manual
Memorex DVD Player MVDP1086 User Manual
Metra Electronics Ventilation Hood 99 8151 User Manual