Lightolier Indoor Furnishings 1102TM1 User Manual

Lytecaster® Recessed Downlighting 1102TM1  
Page 1 of 1  
6 3/4 ” Aperture Low Profile 2 Lt. 13W Emergency Fluorescent Frame-In Kit  
Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.  
Frame-In Kit  
Reflector Trims — See Individual Reflector Trim Specification Sheets  
Enclosed  
Diffusers  
Wall  
Washer  
Open Downlight  
Cone  
Baffles  
Cross Blade  
1102TM1  
1102TM2  
HPF 120V 1113TGD  
HPF 277V 1113TCL  
1105T  
1105TWH  
1132T  
1126T  
1128T  
1178T  
1135T  
Features  
Electrical  
1. Mounting Frame: .036" (#20 ga.) galvanized steel. Accommodates all  
ceilings up to 1" thick. Low profile 3 7/8" depth including ceiling material and  
reflector trim. For ceilings thicker than 5/8", depth from finished ceiling will  
be ceiling thickness (max. 1") plus 3 1/4". Push-in/twist-out rotoclips hold  
reflector flush to ceiling.  
120V  
31  
0.28  
277V  
42  
0.17  
HPF Input Watts  
Amps  
Minimum starting time is 32° F.  
Options & Accessories  
Concealed Spline Ceiling Kit:  
Plaster Ceiling Ring:  
2. Junction Box: .063" (#14 ga.) galvanized steel. Rated for 8 #12 AWM  
through branch circuit wires suitable for 90° C, for end of run 75° C. Quick  
release “L” shaped cover for access to wiring. Integral cable clamps permit  
attachment of nonmetallic Romex® or armored cable without need of  
additional connectors.  
3. Mounting Bars: Die-formed steel, #16 ga. Four bars, 13" long, extend to  
27", permit off-center mounting; bars rotate 90° and lock in both directions;  
integral poised nailer for wood joists, locking tabs for T-bar runners.  
4. Socket Housing: 22 ga. galvanized spring steel; snap-in quick assembly for  
precise lamp location.  
1965 - set of (4), 1 1/2” to 2 1/2” Mtg. Ht.  
1961 - 7/8" depth for wet plaster ceilings.  
Labels  
UL (Suitable for Damp Locations), I.B.E.W.  
Romex® is a registered trademark of General Cable Industries Inc.  
US Patent No.: patent pending  
5. Socket: Two-pin base, molded thermoplastic; prewired with #18 AWM leads  
to 4" x 3 1/2” x 2" junction box.  
6. Thermally Protected Ballast: 2 light electromagnetic, encased and potted,  
class "P" high power factor. Insulation must be kept 3" away from fixture  
sides and wiring compartment and must not be placed above fixture as to  
entrap heat.  
Job Information  
Type:  
Job Name:  
Cat. No.:  
Lamp(s):  
Notes:  
7. Emergency Power Pack: Electronic, fully encased and pre-wired nickel  
cadmium long life battery, replaceable from below. Meets requirements of  
National Electric Code and Life Safety Code. Test switch and charge light  
included in easy to install recessed switch box with 4 1/2” diameter matte  
white cover plate, 24" long flexible cable; may be installed up to 50 feet from  
fixture. One lamp operates at 61% initial output for 90 minutes when power  
fails.  
Lightolier a Genlyte company  
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710  
We reserve the right to change details of design, materials and finish.  
© 2006 Genlyte Group LLC • E0506  
 

Lenovo Stereo System 7387 User Manual
LG Electronics Dishwasher 3828DD3003L User Manual
LG Electronics Microwave Oven LCRM1240SW User Manual
Lindy Computer Accessories 32353 User Manual
Logitech Webcam C160 User Manual
Lucent Technologies Telephone 8101 User Manual
Magnadyne Stereo Receiver LS8600UCDW User Manual
Maytag Dishwasher W10185072A User Manual
Melissa Fryer 743 193 User Manual
Metz Camcorder Astral MF 63 TG 63 100 MT Spectral MF 55 TG 68 100 MT Nordkap S 70 TG 73 100 MT Stratos SF 72 TG 85 100 MT Linos S 84 TG 87 100 MT User Manual